Type CDF ceiling
mounted fan forced heaters are designed for commercial and
industrial areas requiring electric fan forced heat. Capacities
are 2,000 to 5,000 watts. Type CDF SE surface enclosures are
designed to mount flat on the ceiling and extend only six inches
into the room.
Type CDF RE
enclosures have no protrusions outside the recess box, allowing
the heater to recess only seven inches into ceiling space. Mounts
into permanent ceiling with trim ring.
Built In Fan Delay
— Space temperature is controlled by a wall or unit mounted
thermostat. When the thermostat calls for heat, the heating
elements and fan energize. When the thermostat is satisfied, the
elements shut off, but the fan continues to operate until all of
the heated air is discharged. This feature avoids exposing the
heater to residual heat, thus achieving a high comfort level and
longer component life.
Automatic Thermal
Cutout — A thermal cutout shuts off the heater in the event of
overheating and reactivates the heater when the temperature
returns to normal.
Multiple Phase
Heaters — The 208 and 240 volts heaters can be field converted
from single to three phase operation. 277 volt single phase heaters
are also available.
Multiple Wattage
Heater Sections — The 5,000 watt heater can be field converted
to 3,800 watts or 2,500 watts, and the 4,000 watt heater is
convertible to 3,000 or 2,000 watts.
Single Person Hands
Free Installation — Every heater has two installation aids
unique to the industry-Spring Clips temporarily support the heater
section until the mounting hardware is secured. Thumb Pins align
and temporarily hold the enclosure cover to the heating section
freeing both hands to finish installation.
"Thermostats
and other accessories sold separately, unless otherwise
noted"
